|
04-20-2009, 09:21 AM
|
#1
|
Member
Join Date: Jun 2008
Posts: 34
SUN #637
|
Help with sealant for roof penetrations
I discovered this weekend while cleaning the roof on our Sunline that the shroud hood for the antenna roof penetration has come loose and is not sealed, thus opening the penetration to leaking.
I want to make sure that I use the right sealant to close this back up and I'm not 100% sure what sealant to use on the rubber roof. Can anybody point me in the right direction?
Thanks,
Tom
__________________
__________________
|
|
|
04-20-2009, 10:06 AM
|
#2
|
Moderator
Join Date: Dec 2006
Location: Michigan
Posts: 6,155
SUN #123
|
Hi Tom,
Dicor #501 Self-leveling Lap Sealant, available at most RV dealers.
Jon
__________________
__________________
2007 T-286SR Cherry/Granola, #6236, original owner, current mileage: 9473.8 (as of 6/18/21)
1997 T-2653 Blue Denim, #5471
1979 12 1/2' MC, Beige & Avocado, #4639
Past Sunlines: '97 T-2653 #5089, '94 T-2251, '86 T-1550, '94 T-2363, '98 T-270SR
|
|
|
04-23-2009, 09:43 AM
|
#3
|
Member
Join Date: Jun 2008
Posts: 34
SUN #637
|
I actually went with the Dicor #551 since I wanted it to stack up around the antenna shroud for the penetration and the label indicated that non-self leveling is a better way to go for that.
I haven't done this repair yet, but I expect to get to it at one of the campgrounds in the next couple of days. I'll update this post and add some pictures once thats sorted.
Thanks for the help.
--Tom
TT - 2004 Solaris Lite T-2199
Tow - 2005 V8 Toyota Tundra SR5
http://www.wearezinks.com
__________________
|
|
|
05-10-2009, 08:01 PM
|
#4
|
Member
Join Date: Jun 2008
Posts: 34
SUN #637
|
Just wanted to update a couple of threads and close them out. I did the reseal on the weather hood for the antenna cable and it turned out all good. I have not tested it with water since I don't think I would be able to immediately tell if the hood was leaking. I layered the sealant on both before I slid the hood down and around the top and base of the hood so I am pretty confident it is finished.
Like I said previously I went with a non-leveling sealant so it would hold to the somewhat vertical position I needed it to on the weather hood.
Two things I noted when doing this.
1 - It would be so nice if you could get small tubes of Dicor. I had to by a whole tube for probably 1.5 oz of material I needed, and I doubt it will save and work for the next time I need it.
2 - Dicor is STICKY. I had a hard time getting a nice smooth finish on it with my finger as it would just stick to my finger and then peak up when I tried to smooth it, anybody have any tricks for smoothing it out?
--Tom
__________________
|
|
|
05-10-2009, 09:15 PM
|
#5
|
Senior Member
Join Date: Apr 2007
Location: New York
Posts: 1,846
SUN #264
|
Quote:
Originally Posted by thesteigers
2 - Dicor is STICKY. I had a hard time getting a nice smooth finish on it with my finger as it would just stick to my finger and then peak up when I tried to smooth it, anybody have any tricks for smoothing it out?
|
Keep your finger wet with water while you smooth it.
Works not only with Dicor but most any caulking material.
(I caulked a whole log house that way.... )
__________________
'12 F250 4x4 Super Duty PowerStroke 6.7 diesel
2011 to present: '11 Cougar 326MKS
1999 to 2011: '99 Sunline T-2453
SUN264 * Amateur Radio kd2iat monitoring 146.52
|
|
|
05-10-2009, 09:18 PM
|
#6
|
Moderator
Join Date: Nov 2006
Location: Ohio
Posts: 12,654
SUN #89
|
Quote:
Originally Posted by Steve Collins
Keep your finger wet with water while you smooth it.
Works not only with Dicor but most any caulking material.
(I caulked a whole log house that way.... )
|
Neat tip. Did not know that.
Now the whole log house....I'll bet there is a campfire story in there somewhere
John
__________________
Current Sunlines: 2004 T310SR, 2004 T1950, 2004 T2475, 2007 T2499, 2004 T317SR
Prior Sunlines: 2004 T2499 - Fern Blue
2005 Ford F350 Lariat, 6.8L V10 W/ 4.10 rear axle, CC, Short Bed, SRW. Reese HP trunnion bar hitch W/ HP DC
Google Custom Search For Sunline Owners Club
|
|
|
05-10-2009, 09:19 PM
|
#7
|
Senior Member
Join Date: Sep 2006
Location: Ontario
Posts: 503
SUN #43
|
Quote:
Originally Posted by thesteigers
J
2 - Dicor is STICKY. I had a hard time getting a nice smooth finish on it with my finger as it would just stick to my finger and then peak up when I tried to smooth it, anybody have any tricks for smoothing it out?
--Tom
|
Although I have not tried this myself yet, I have been told the best way to smooth out the dicor without it sticking to your finger is to put some Goo Gone on the tip of your finger. This apparently prevents the Dicor from sticking to your finger while allowing you to get a nice smooth finish on the Dicor.
Last week I had to change the coax cable on our antenna as it had split. When I replaced the coax cable I found the new boot very loose after I fitting it over the antenna base opening. What I did was first place some dicor into the hole the cable passes through then placed the boot over top and used strips of Eteranbond cut in such a way so they would attach to the boot and holding it to the antenna base. This worked quite well and seems to keep the boot securely in place. I was lucky enough in that mind did not leak. Just glad I found this before I had a problem.
I would strongly suggest everyone check out the boot on their antenna and keep a close eye on it. As the OP stated, if this boot comes off and there is no dicor in the opening, this is a direct path for water to the inside of the coach.
__________________
2018 GMC Denali 3500HD Dually
2018 Grand Design 384GK
Formerly,
2003 F311SR
2005 T-2753
|
|
|
05-10-2009, 09:39 PM
|
#8
|
Moderator
Join Date: Nov 2006
Location: Ohio
Posts: 12,654
SUN #89
|
Quote:
Originally Posted by Trailblazer
I would strongly suggest everyone check out the boot on their antenna and keep a close eye on it. As the OP stated, if this boot comes off and there is no dicor in the opening, this is a direct path for water to the inside of the coach.
|
I second that. Mine had the same issue but I caught it before a leak. There was not much caulk under the boot where the cable goes thru the metal housing to the inside. When we got the camper, used, I checked it and Dicor'ed it up and slide the boot down. Now this year I see the boot keeps lifting up off the metal fitting. While I have dicor under the boot I added a small stainless steel hose clamp to keep the boot stuck down. If seems when the antenna goes up and down as the wire gets older and stiffer, the boot lifts up verses flexing.
John
__________________
__________________
Current Sunlines: 2004 T310SR, 2004 T1950, 2004 T2475, 2007 T2499, 2004 T317SR
Prior Sunlines: 2004 T2499 - Fern Blue
2005 Ford F350 Lariat, 6.8L V10 W/ 4.10 rear axle, CC, Short Bed, SRW. Reese HP trunnion bar hitch W/ HP DC
Google Custom Search For Sunline Owners Club
|
|
|
|
Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)
|
|
Posting Rules
|
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts
HTML code is Off
|
|
|
|
» Recent Sunline Discussions |
|
|
|
|
|
|
|
|
|
|
|
|
|