Mouse entry points - Page 3

jpspaz · 04-07-2011, 03:52 PM

I can't really get to where the pipe is to clean it, but I can get a nozzle in there to fill it with spray foam. Here are some photos.
I'll go back out and get some more of the slide out area.

jpspaz · 04-07-2011, 04:39 PM

Here's a couple more photos showing the slide out corners and weather stripping. I bent it back so you could see the opening.

**JohnB** · 04-07-2011, 07:57 PM

HI Jp

On your seals, what I see on your looks just like the 2005 slide seal. Mine being a 2004 does not have the little "bead" on the end of the wiper part. I have not seen mine, nor do I know if it will make a difference, but I have found 2 places that look like yours.

You can see the little bead on the end of the wiper. Your pic

Slide Out Seal 19-G8135

Slide-out gasket material, RV weather seals, Seal, RV gaskets, Trailer seals, window seals

Check the dimensions. I have never bought from either if these folks, I just book marked them for the day I need to buy new seal material.

Pricing, I know the stuff is not cheap but I have not yet hunted the entire Inet for better cost.

If you find something please post.

Hope this helps

John

jpspaz · 04-13-2011, 04:33 AM

Thanks for the info. I'll check that out. After sealing off the runway under the bathroom sink and two other points where there might have been outside access, I climbed underneath with the sprayfoam can and found another chewed through exit point next to some sort of drain near the hot water heater. I sealed that up and will hope for the best. I'm running out of options. I wish there was an easy and light way to seal up the entire bottom with plexiglas or something.